Epson PowerLite 703c User Manual - Page 34
Turning On and Using the Remote Control, Installing Batteries
View all Epson PowerLite 703c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
caution When replacing batteries, take the following precautions: s Don't mix old and new batteries. s Replace batteries as soon as they run out. If the batteries leak, wipe away battery fluid with a soft cloth. If fluid gets on your hands, wash them immediately. s Do not expose batteries to heat or flame. s Dispose of used batteries according to local regulations. s Remove batteries if you won't be using the projector for a long period of time. Turning On and Using the Remote Control Before using the remote control, you need to install its batteries and turn it on as described below. Installing Batteries Follow these steps to install or replace the batteries: 1. Press the tab to release the battery compartment cover. tab 2. Remove the cover and insert the two AA batteries included with the projector as shown. 3. Replace the battery compartment cover. Freeze A/V Mute E-Zoom Power R/C ON OFF 3 2 5 4 1 Enter Esc on/off switch light button Turning On the Remote Control Make sure batteries are installed. Then push up the on/off switch on the side of the remote control to turn it on. If you want to make sure the batteries are good, press the round light button. The other buttons on the remote should light up temporarily. If they don't, you need to change the batteries as described above. Turn off the remote control before transporting it or storing it in a projector case. This prevents the batteries from discharging if something presses against one of the buttons. 28 Using the Remote Control