Epson Stylus Photo Product Information Guide - Page 4

EPSON Stylus Photo Mechanical Paper feed method Friction Paper path Sheet feeder, rear entry Sheet feeder capacity 100 sheets at 17 lb (64 g/m2) paper Dimensions Storage Width: Depth: Height: Printing Width: Depth: Height: 16.9 inches (429 mm) 10.8 inches (275 mm) 6.6 inches (168 mm) 16.9 inches (429 mm) 24.1 inches (613 mm) 27.4 inches (695 mm) when printing transparencies 12.2 inches (309 mm) 7.7 inches (196 mm) when printing transparencies Weight 11.5 pounds (5.2 kg) without the ink cartridges Electrical Specification Input voltage range Rated frequency range Input frequency range Rated current Power consumption 120V Model 220-240V Model 103.5 to 132V 198 to 264V 50 to 60 Hz 49.5 to 60.5 Hz 0.4A 0.2A Approx. 15W (ISO/IEC 10561 Letter Pattern) Note: Check the label on the back of the printer for the voltage rating of your printer. Environmental Temperature Operation: Storage: 50 to 95 °F (10 to 35 °C) -4 to 140 °F (-20 to 60 °C), stored in shipping container 1 month at 104 °F (40 °C) 120 hours at 140 °F (60 °C) Humidity Operation: Storage: 20 to 80% RH (without condensation) 5 to 85% RH (stored in shipping container, without condensation) Safety Approvals Safety standards UL 1950 with D3, CSA C22.2 No.950 with D3 EMC FCC part 15 subpart B class B, CSA C108.8 class B Interface Your printer is equipped with an 8-bit parallel interface and a Macintosh® serial interface. Parallel interface The built-in parallel interface has the following characteristics: Forward channel Data format: 8-bit parallel, IEEE-1284 compatibility mode Synchronization: STROBE pulse Handshake timing: BUSY and ACKNLG signals Signal level: TTL compatible Connector: 57-30360 Amphenol connector or equivalent Reverse channel Transmission mode: IEEE-1284 Nibble mode Adaptable connector: 57-30360 Amphenol Connector or equivalent Synchronization: Refer to the IEEE-1284 specification Handshaking: Refer to the IEEE-1284 specification Signal level: IEEE-1284 Level 1 device Data transmission timing: Refer to the IEEE-1284 specification Serial interface The printer's built-in serial interface is based on the RS-423 standard. This interface has the following characteristics: Standard: Based on RS-423 Synchronization: Synchronous Bit rate: Approx. 900 Kbps Handshaking: X-ON/X-OFF, DTR protocol 4 - EPSON Stylus Photo 3/97