Epson Stylus Pro 9880 UltraChrome User's Guide - Page 29
Unpacking and Assembling the Epson Stylus Pro 9880, using the Epson Stylus Pro 9880
View all Epson Stylus Pro 9880 UltraChrome manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Setting Up the Printer | 29 5. If you find that your roll paper is curled too tightly to eject properly, attach the two paper guides to the bottom of the printer. See page 175 for more information. 6. Unlock the casters. Then move the printer to the place of use. (The casters are meant for moving the printer for only a short distance.) Lock the casters after moving. 7. Make sure you save the box and packaging in case you need to ship the printer. Now go to "Connecting the Power Cord" on page 39. Unpacking and Assembling the Epson Stylus Pro 9880 WARNING: Two people are required to unpack the printer, and four are needed to set it on the stand. Follow these steps to assemble your printer and its stand. (If you have the Epson Stylus Pro 7880, see page 19 instead.) Before you begin, make sure you have sufficient space to set up and use the printer. The following illustration shows the minimum space required for using the Epson Stylus Pro 9880: Note: When choosing a place for the printer, leave adequate room for easy access and ventilation. Avoid locations subject to direct sunlight, excessive heat, moisture, or dust. Also avoid locations near potential sources of electromagnetic interference, such as loudspeakers, cordless phones, TVs, or air conditioners. 12 in. (30 cm) 24 in. (61 cm) 12 in. (30 cm) 12 in. (30 cm) You will also need floor space of approximately 13 × 13 feet (4 × 4 m) to assemble the printer and stand. 29