Epson TM-P60 User Guide - Page 13

English 5. Align the left edge of the roll paper with the edge of the cover. See ➂ in illustration D. 6. Close the roll paper cover and tear off the paper with the manual cutter. Buzzer The factory default is set to On (buzzer sounds) to indicate the following: ❏ Remaining battery charge is not adequate ❏ Host disconnection ❏ Roll paper end ❏ Error ❏ Transmission of status information Belt Clip See illustration E. You can hang the printer on your belt using the belt clip attached to the back of the printer. If you want to hang the printer on your neck, you can use the neck strap provided as an option. Troubleshooting No lights on the control panel ❏ Check that the battery is installed. ERROR LED is flashing or on ❏ The printer temperature may be too high. The printer resumes printing automatically when the temperature returns to normal. ❏ Make sure that the roll paper cover is properly closed. ❏ Make sure that roll paper is installed. ❏ When the printer power is on, if the ERROR LED and the BATT. LED are on, the remaining battery charge is not enough for printer operation. The battery must be fully charged. ❏ When the battery is being charged, if the ERROR LED is on, an abnormality has occurred. The battery must be replaced with a new one. ❏ Turn off the power, wait several seconds, and then turn it on again. If the error remains, contact a qualified service person. Cleaning the Thermal Head CAUTION: After printing, the thermal head can be very hot. Be careful not to touch it and to let it cool before you clean it. Do not damage the thermal head by touching it with your fingers or any hard object. Turn off the printer, open the paper roll cover, and clean the thermal elements of the thermal head with a cotton swab moistened with an alcohol solvent (ethanol, methanol, or IPA). See illustration F. EPSON recommends cleaning the thermal head periodically (generally every 3 months) to maintain print quality. TM-P60 User's Manual (IEEE802.11b) 9