Epson V11H179020 Product Information Guide - Page 13
Resetting the Lamp Timer
UPC - 010343853997
View all Epson V11H179020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
3. Loosen the lamp cover screw with the screwdriver that is supplied with the spare lamp (or your own cross head [Phillips] screwdriver). 4. Then slide the lamp cover straight forward and lift it to remove. Epson PowerLite S3 Projector 7. Insert the new lamp so that it fits in place correctly. Once it is fully inserted, tighten the two screws. 5. Loosen the two lamp screws with the screwdriver that is supplied with the spare lamp (or your own cross head [Phillips] screwdriver). 8. Slide the lamp cover onto the projector and tighten the cover screw. 6. Take out the lamp. Hold the lamp as shown in the illustration below and lift it up and out of the projector. If the lamp is broken, replace it with a new lamp, or contact Epson for further advice. If replacing the lamp yourself, be careful to avoid pieces of broken glass. Note: Install the lamp securely. If the lamp cover is removed, the lamp turns off automatically as a safety precaution. Moreover, the lamp will not turn on if the lamp or the lamp cover is not installed correctly. The lamp contains mercury. Dispose of used lamps properly in accordance with your local regulations. Resetting the Lamp Timer The projector has a built-in counter which keeps track of the lamp operating time. When the cumulative operating time reaches a certain point, it causes the replacement warning message to be displayed. Therefore, the counter needs to be reset after the lamp has been replaced with a new one. You can do this using the configuration menu. Note: Do not reset the lamp operating time except after the lamp has been replaced, otherwise the lamp replacement period will not be indicated correctly. 1. Connect the power cable and turn on the projector. 3/05 Epson PowerLite S3 Projector - 13