Eufy RoboVac 11S RoboVac 11S11S Max15C Max_EN_Manual - Page 7

• Install 2 AAA batteries before using the remote control for the first time. Make sure the positive and negative ends are facing the correct polarity direction as marked in the battery compartment. LED Indication You can see the status of RoboVac from the LED indicator. Using Your RoboVac Important Tips Before Use A B C Status (Status Light) Breathing orange Charging Solid blue Standby / Cleaning / Fully charged Solid orange Low power and returning to Charging Base O Flashing / Solid red + Beeping 10 EN • RoboVac is off. • To conserve power, the light automatically turns off when RoboVac is not docked to the Charging Base and has been inactive for 1 minute. • RoboVac has an error. • Refer to the "Troubleshooting>Error Tone" section in this manual for solutions. Remove power cords and small objects from the floor that may entangle RoboVac. Fold tasseled edges of rugs underneath to prevent tangling RoboVac. Avoid cleaning dark-colored high-pile rugs or rugs thicker than 1.02 in / 26 mm as they may cause RoboVac to malfunction. It is strongly recommended to place physical barriers in front of fireplaces and certain areas (i.e. air vents) that may cause damage to RoboVac if entered. D E F Keep RoboVac away from wet areas during cleaning. RoboVac may climb on top of objects less than 0.63 in / 16 mm in height. Remove these objects if possible. Anti-drop sensors prevent RoboVac from tumbling down stairs and steep drops. They may work less effectively if dirty or used on reflective/very dark-colored floors. It is recommended to place physical barriers to block off areas where RoboVac may fall, such as stairs covered by carpets or the rounded edges of wood floors. Preparation 1 Install the side brush before use. • Remove the foam blocks beside the bumper before use. 3 Place the Charging Base on a hard, level surface and against a wall. 4 Remove objects within 3ft / 1 m of the left and right side and within 6ft / 2 m of the front of the Charging Base. If you cannot remove the objects, check whether RoboVac can return to the Charging Base normally; if not, contact eufy customer service for help. 2 Turn on the main power switch on the bottom of RoboVac. OFF ON • Do not place the Charging Base within 3ft / 1m from the stairs or cliff. EN 11