Eureka LightSpeed 4700D Owners Manual - Page 25

ENGLISH Problem Solving CAUTION: Turn off the switch and unplug the electrical cord before servicing. Problem Motor will not start. Cause Electric Plug Motor suddenly stops. Hard to push. Does not clean the carpet/floor. Thermal Cut Off Carpet Height Adjustment Dust Cup Filter Belt Brushroll No suction at the hose. Hose Carpet Height Adjust Dust Cup and Filter Hose Headlight is not working. (some models only) Noise from the brushroll area. Brushroll will not turn. Light Bulb/not available Brushroll Belt Brushroll Burning smell. Power Paw™ stair brush doesn't work. (some models only) Belt Brushroll/Belt Missing parts or questions. Call 1-800-282-2886 for customer assistance. Solution • Push plug securely into outlet. • Try another outlet. • Check circuit breaker. • Refer to pages 3 and 13. • Adjustment set too low. • Empty the dust cup. • Make sure dust cup is installed properly and dust cup latch is secured. • Make sure pleated filter is clean. • Replace cut, loose, out of shape belt. • Clean hair and thread from bristles and end cap area. • Replace brushroll if bristles are worn. • Remove any clogs from the hose that restrict the airflow. • Adjustment set too high. • Empty the dust cup • Clean and install filter properly. • Make sure dust cup is installed properly and dust cup latch secured. • Remove any clogs from the hose that restrict the airflow. • Check both ends of the hose. • Replace light bulb. • Remove hood and clean debris from the brushroll area. • Replace a cut, loose or out of shape belt. • Remove hood and clean debris from the brushroll area. • Replace broken belt. • Remove hood and clean debris from the brushroll area/belt. • Remove any clogs from the opening or debris around the brushroll or belt. Thermal Cut Off This cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the cleaner suddenly turns off, follow this procedure: Step 1: Push on/off switch to off. Step 2: Unplug cleaner. Step 3: Check for source of overheating problem (i.e. full dust cup, clogged hose or clogged filters). Step 4: If a full dust cup, clogged hose or clogged filters are found, empty the dust cup, unclog the hose or replace the filters. Step 5: Wait at least 30 minutes before attempting to reuse the cleaner. Step 6: After 30 minute cool down period, plug the cleaner in and push the switch pedal. The cleaner should turn on. Step 7: If the cleaner still does not operate, call 1-800-282-2886 for customer assistance. 25