Fagor 15 Inch Beverage Center User's Manual - Page 10

Setting the Temperature Control • The unit has a single temperature zone. The temperature can be set between 36ºF and 43ºF (2ºC and 6ºC). • When the unit is plugged in for the first time, the unit will power up automatically to the preset defaults. The default temperature is 38ºF (3°C). • You can set the temperature by pressing the UP and DOWN buttons. When you press the UP or DOWN buttons, the displayed temperature will change accordingly. • The temperature will increase 1ºF or 1ºC if you press the UP button once. The temperature will decrease 1ºF or 1ºC if you press the DOWN button once. The display will flash while you make your selection. TEMPERATURE DISPLAY During normal operation, the temperature display on the control panel always shows the SET temperature. The temperature display will flash if - A different temperature is being set. - The temperature in the zone deviates by more than 9°F or 5°C from the set temperature. The temperature display flashing ensures that the temperature cannot rise or fall un-noticed. TEMPERATURE MEMORY FUNCTION In the event of a power interruption (power surge, breaker switch failure, etc.), the unit will remember the last temperature settings and, when the power is recovered, the cabinet temperature will go back to the same set temperature as before the power interruption. TEMPERATURE ALARM An alarm will sound if the temperature rises or falls outside the temperature range. The temperature display will flash at the same time. The temperature the appliance is set at determines the temperature the appliance recognizes as being too warm or too cool. The alarm will sound and the temperature display will flash: - If the temperature inside the appliance is very different from the temperature set. This does not include the very first time the unit is turned on. - When there has been a lengthy interruption to the power supply. - When too many items have been put into the unit at one time. This can be as a result of holding the door open too long or from overloading the unit past its recommended capacity. - When the door is not been closed tightly. THE ALARM CAN BE DEACTIVATED BY PRESSING THE POWER BUTTON DOOR ALARM If the door has been left open for more than 60 seconds, the alarm will sound. Once the set temperature has been reached in the appliance, the alarm stops and the relevant temperature display stops flashing. However, if the noise disturbs you, you can switch the alarm off before this if you wish by pressing the POWER button once. The alarm will stop. The temperature display continues to flash until the set temperature has been reached. The display then lights up constantly and the alarm system is fully active again. INTERIOR LIGHT The interior light makes it easy to view your beverage labels and enhances the display of your collection. Touching the LIGHT button toggles between 2 modes of operation for the internal lights: functional (default) mode and showcase mode. If you are in functional (default) mode, the lights will turn on only when the door is open. If you are in showcase mode, the lights will remain on whether or not the door is open. The unit is equipped with a LED light fitting system. To change the LED light fitting please contact the service department. NOTE: Please use only the original LED light fittings provided by the manufacturer. 10