Fagor 15 Inch Beverage Center User's Manual - Page 5

PRODUCT FEATURES • Built-in or free-standing installation. • Temperature can be set from 36°F to 43°F (2°C to 6°C) and can be displayed in either Fahrenheit or Celsius. • Dynamic compressor type cooling to ensure interior air circulation with even distribution of temperature. • Soft White LED Interior Light with ON/OFF switch making it easier to view your content without opening the door. • Open-door and malfunction warning system. • Sabbath mode will allow the lights to remain off during certain religious observances. • Temperature memory function - If power is interrupted (power surge, breaker switch, etc.) and then powered up again, the unit will operate at the last temperature set-point. • Automatic defrosting with defrost water evaporation. • Reversible tempered double pane light gray glass door creates an attractive display with little condensation and minimal noise. • Black coated matte steel outer frame and black plastic interior liner. • Stainless steel-framed glass door with stainless steel handle. • Roll-out and adjustable shelves allow for maximum convenience and flexibility to accommodate various sized bottles. • Refrigerant and foaming insulation glass are all CFC, HCFC and HFC free, making them environmentally friendly. INSTALLATION Reversing the door Hinge. • Install the handle on the door. INSTALLATION OF YOUR APPLIANCE • The appliances are designed to be built-in or free standing. • CAUTION: This appliance is designed for storing and cooling beverages. Do not store perishable food, medicine or other medical products in this unit. • Place your appliance on a floor that is strong enough to support it when it is fully loaded. To level your unit, adjust the front adjustable legs at the bottom of the unit. • For free-standing installation, 5 inches (127mm) of space between the back and sides of the unit are suggested, which allows the proper air circulation to cool the compressor and condenser for energy saving. Even for built-in installation, you must keep ¼" (5mm) space on each side and at the top to ensure proper service access and ventilation. The air vent at the front of the appliance must never be covered or blocked in any way! • Install the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly. BEFORE USING YOUR APPLIANCE • Remove all exterior and interior packing. Clean the interior surface with lukewarm water using a soft cloth. The unit may have residual odors at first; they will disappear as the unit cools. • IMPORTANT: Before connecting the unit to the power source, let it stand upright for approximately 24 hours. This will reduce the possibility of a malfunction in the cooling system caused by handling during transportation. • The door on this appliance can be opened from either the left or the right side. The unit is delivered with the door opening on the right side. Should you wish to open the door from the left, follow the instructions in the section titled • Avoid installing the unit in damp areas such as garages and damp basements. • Plug the unit into its own, easily accessible and properly grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed towards a qualified electrician or an authorized products service center. • The appliance must be installed to all electrical, plumbing, water and drain connections in accordance with state and local codes. • IMPORTANT: HIGH HUMID CLIMATE. During periods of high humidity, some condensation may appear on the outside surfaces of the glass 5