Fagor 24 Inch Tower Wine Cooler User's Manual - Page 17

Reversing the Door Hinge

Get Fagor 24 Inch Tower Wine Cooler PDF manuals and user guides View all Fagor 24 Inch Tower Wine Cooler manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

The light does not work. Vibrations. The appliance seems to make too much noise. The door will not close properly. Display shows "E1". "E2" or "E7". The alarm sounds and the temperature display flashes. The display shows "--". 1. Appliance is not connected to a power supply. 1. Connect the appliance. 2. The circuit breaker tripped or blew a fuse. 2. Switch on circuit breaker or replace fuse. 3. The light was switched off on the control panel. 3. Switch on the light. 1. The appliance is not properly leveled. 1. Level the appliance with the adjustable feet. The rattling noise may come from the flow of the refrigerant, which is normal. As each cycle ends, you may hear gurgling sounds caused by the flow of refrigerant in your appliance. If temperature fluctuations occur, the contraction and expansion of the inner walls may cause popping and cracking noises. 1. The appliance is not properly level. 1. Level the appliance with the adjustable feet. 1. The appliance is not properly leveled. 1. Level the appliance with the adjustable feet. 2. The door was reversed and not properly 2. Check the door hinge and installed. reassemble correctly (See Reversing the Door Hinge section on page 8). 3. The gasket is dirty. 3. Clean the door gasket. 4. The shelves are out of position. 4. Check the shelves and reposition correctly. 1. "E1" or "E2" indicates that the air temperature Call for service. sensor is failed. 2. E7" indicates the door switch failure. Has the appliance door been open for longer than 60 seconds? If yes, close the door. If not, then the temperature has risen higher or fallen lower than the temperature that has been set. This could be due to: 1. The appliance door being opened too often. 1. Do not open the door more often than necessary. 2. The ventilation opening being covered or too 2. Clear the obstructions and clean dusty. the dust. 3. A lengthy interruption to the power supply. 3&4.Leave the appliance untouched 4. A large amount of bottles has been added to for a while until the set temperature the unit. has been reached. 1. The display temperature is out of the range. 1. Only temperatures within the range 16~99°F/-9~37°C will be shown. If the temperature is not within this range, the icon "--" will be displayed instead. That is normal. 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
The light does not
work.
1.
Appliance is not connected to a power supply.
2.
The circuit breaker tripped or blew a fuse.
3.
The light was switched off on the control panel.
1. Connect the appliance.
2.
Switch on circuit breaker or
replace fuse.
3.
Switch on the light.
Vibrations.
1.
The appliance is not properly leveled.
1.
Level the appliance with the
adjustable feet.
The appliance seems
to make too much
noise.
The rattling noise may come from the flow of the refrigerant, which is normal. As each cycle
ends, you may hear gurgling sounds caused by the flow of refrigerant in your appliance.
If temperature fluctuations occur, the contraction and expansion of the inner walls may
cause popping and cracking noises.
1.
The appliance is not properly level.
1.
Level the appliance with the
adjustable feet.
The door will not
close properly.
1.
The appliance is not properly leveled.
2.
The door was reversed and not properly
installed.
3.
The gasket is dirty.
4.
The shelves are out of position.
1.
Level the appliance with the
adjustable feet.
2.
Check the door hinge and
reassemble correctly (See
Reversing the Door Hinge
section on page 8).
3.
Clean the door gasket.
4.
Check the shelves and
reposition correctly.
Display shows “E1”.
“E2” or “E7”.
1.
“E1” or “E2” indicates that the air temperature
sensor is failed.
2.
E7” indicates the door switch failure.
Call for service.
The alarm sounds
and the temperature
display flashes.
Has the appliance door been open for longer than
60 seconds? If yes, close the door. If not, then the
temperature has risen higher or fallen lower than
the temperature that has been set. This could be
due to:
1. The appliance door being opened too often.
2. The ventilation opening being covered or too
dusty.
3. A lengthy interruption to the power supply.
4. A large amount of bottles has been added to
the unit.
1.
Do not open the door more often
than necessary.
2.
Clear the obstructions and clean
the dust.
3&4.Leave the appliance untouched
for a while until the set temperature
has been reached.
The display
shows “--”.
1.
The display temperature is out of the range.
1.
Only temperatures within the
range 16~99°F/-9~37°C will be
shown. If the temperature is not
within this range, the icon “--”
will be displayed instead. That is
normal.
17