Fisher and Paykel OR36SDBMX1 User Guide - Page 26
Fitting And Removing The Sliding Shelf Supports, Fitting The Side Racks, Removing The Side Racks
View all Fisher and Paykel OR36SDBMX1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
5 FITTING THE SIDE RACKS 1. Place the side racks in oven. Make sure that they are the right way up, as in the illustration, and then insert and tighten the front and rear fixing screws. 2. If not already fitted, fit the telescopic sliding shelf supports. See "Fitting and removing the sliding shelf supports. Note: Do not use the first step from the top. REMOVING THE SIDE RACKS 3. Using a small coin or a flat-head screwdriver, loosen and remove the front and rear fixing screws. 4. Remove the side rack. Fig. 5.8 FITTING AND REMOVING THE SLIDING SHELF SUPPORTS When fitting the sliding shelf supports, make sure that you fit: - the slides to the top wire of a shelf position on the side racks - both sides of each pair of slides on the same level. Important! Do not use on shelf position 1 or 2. Remove the side racks first to make removing the sliding shelf supports easier. Fig. 5.9 26 1 2 1 Fig. 5.10