Fluke 576 FE 576 Users Manual - Page 28

576 Troubleshooting Sometimes a long beep and the red LED above the display shines to indicate a problem, check your display to find out which problem has occured. Symptom Display Code Problem Action Camera cannot send photos to the PC Driver installation failed Open Harware Manager on the PC to fix it -O- Target temperature is over Select target -U- or under range within unit's specs EEPROM-Err CalAreaErr ProbCalEr Flash needs too long to charge or does not charge at all EEPROM error calibration errors Battery is low Blank display Laser won't work Battery is dead Low or dead battery Ambient above 45°C (113°F) Display "ON" Photos lost Display locked "ON" Batteries changed before shutdown or too long after removing old ones PC displays "logger The setup in the unit and file does not match in the PC software do not device logger setup" match 28 Contact Factory Contact Factory Replace Batteries Replace Batteries Replace Batteries Operate unit in 45°C (113°F) ambient or below Disconnect the unit from the PC Wait for shutdown to end. (blank screen) Change batteries within two minutes of removing old ones Click "OK". Either save the current data to a new file name or find the correct *.lgg file, open it in "Setup Device Logger", save, and redownload the data with the "Data Logger/Load Device Data Logger"