Fluke 725Ex FE 725ex Users Manual - Page 23
AO Bl CA DK EC FF GD HG IH JI KJ LL, Table 4. Key Functions, Description
View all Fluke 725Ex manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Getting Acquainted with the Calibrator Table 4. Key Functions No. Key Description A O Turns the power on and off. B l Selects voltage, mA, or loop power measurement functions in the upper display. Clears the switch test. See "Switch Test". Selects the pressure measurement function in the upper display. Repeated pushes cycle through C A the different pressure units. Use for pressure switch test. See "Switch Test". D K Zeros the pressure module reading. This applies to both upper and lower displays. E C Turns backlight on and off. F F Toggles between frequency and ohms measurement and sourcing functions. G D Toggles between Centigrade and Fahrenheit when in TC or RTD functions. H G Recalls a source value from memory corresponding to 100 % of span and sets it as the source value. Press and hold to store the source value as the 100 % value. I H Increments output by 25 % of span. J I Decrements output by 25 % of span. K J Recalls a source value from memory corresponding to 0 % of span and sets it as the source value. Press and hold to store the source value as the 0 % value. Cycles through : L L E Slow repeating 0 % - 100 % - 0 % ramp P Fast repeating 0 % - 100 % - 0 % ramp N Repeating 0 % - 100 % - 0 % ramp in 25 % steps 13