Fluke 725Ex FE 725ex Users Manual - Page 38
Measuring Pressure
View all Fluke 725Ex manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
725Ex Users Manual Measuring Pressure Many ranges and types of pressure modules are available from Fluke. See "Accessories" near the back of this manual. Before using a pressure module, read its instruction sheet. The modules vary in use, media, and accuracy. Figure 12 shows the Gage and Differential modules. Differential modules also work in gage mode by leaving the low fitting open to atmosphere. To measure pressure, attach the appropriate pressure module for the process pressure to be tested Proceed as follows to measure pressure: W Warning Use only Fluke 700PEx series pressure modules. To avoid a violent release of pressure in a pressurized system, shut off the valve and slowly bleed off the pressure before attaching the pressure module to the pressure line. Gage PRESSURE MODULE RANGE BURST PRESSURE 300 PSIG Low Differential PRESSURE MODULE RANGE BURST PRESSURE 45 PSIG High aly11f.eps Figure 12. Gage and Differential Pressure Modules WCaution • To avoid mechanically damaging the pressure module, never apply more than 10 ft.-lb. (13.5 Nm) of torque between the pressure module fittings, or between the fittings and the body of the module. Always apply appropriate torque between the pressure module fitting and connecting fittings or adapters. • To avoid damaging the pressure module from overpressure, never apply pressure above the rated maximum printed on the pressure module. 28