Fluke ii910 Product Manual - Page 8
Power On/Off, Battery
View all Fluke ii910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Shop for Fluke products online at: www. ii900/ii910 Users Manual Power On/Off To turn on the Imager, push and hold >2 s. To turn off the Imager, push . Tap OK to continue. Battery XW Warning To prevent personal injury and for safe operation of the Product: • Do not put battery cells and battery packs near heat or fire. • Do not put in sunlight. • Do not disassemble or crush battery cells and battery packs. • Remove batteries to prevent battery leakage and damage to the Product if it is not used for an extended period. • Connect the battery charger to the mains power outlet before the charger. • Use only Fluke approved power adapters to charge the battery. • Keep cells and battery packs clean and dry. Clean dirty connectors with a dry, clean cloth. W Caution To prevent damage to the battery: • Do not expose battery to heat sources or hightemperature environments such as an unattended vehicle in the sun. • Do not store the battery on the charger for more than 24 hours as reduced battery life may result. • Charge the battery for a two-hour minimum at six-month intervals for maximum battery life. Without use, the battery will self-discharge in approximately six months. • Always operate in the specified temperature range. • Do not incinerate the Product and/or battery. A Li-ion battery powers the Imager. The Imager includes two batteries for a quick-change during operation. The battery charges on the 2-bay charging base. The power supply powers the charging base. Country-specific adapters are included. The battery is tested in accordance with and complies to: • UN Manual of Tests and Criteria Part III Subsection 38.3 (ST/SG/AC.10/11/Rev.5) - also known as the UN T19.T8 tests • EN55022 and EN55024 • FCC part 15B • UL2054/cUL60950-1 • IEC62133 • ROHS MyFlukeStore.com 1.888.610.7664 4