Foxconn D42S English Manual - Page 18
Front Panel Connector : FP1, Serial ATA Connectors : SATA_1/2, IrDA Connector : IR/CIR1
View all Foxconn D42S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
2 Front Panel Connector : FP1 This motherboard includes one connector for connecting the front panel switch and LED Indicators. Hard Disk LED Connector (HDD-LED) Connect to the chassis front panel IDE indicator LED. It indicates the active status of the hard disks. This 2-pin connector is directional with +/- sign. 1 + HDD-LED - 2 + PWR-LED - RESET-SW PWR-SW NC EMPTY 9 10 FP1 Reset Switch (RESET-SW) Attach the connector to the Reset switch on the front panel of the case; the system will restart when the switch is pressed. Power LED Connector (PWR-LED) Connect to the power LED indicator on the front panel of the chassis. The Power LED indicates the system's status. When the system is in operation (S0 status), the LED is on. When the system gets into sleep mode (S1) , the LED is blinking; When the system is in S3/S4 sleep state or power off mode (S5), the LED is off. This 2-pin connector is directional with +/- sign. Power Switch Connector (PWR-SW) Connect to the power button on the front panel of the chassis. Push this switch allows the system to be turned on and off rather than using the power supply button. Serial ATA Connectors : SATA_1/2 The Serial ATA connector is used to connect with SATA Hard Disk or CD devices which supporting this feature. The current Serial ATA II interface allows up to 300MB/s data transfer rate. IrDA Connector : IR/CIR1 This connector supports infrared wireless transmitting and receiving device. 11 1 GND TX+ TXGND RXRX+ GND SATA _1/2 12 +5V +5VSB EMPTY CIRRX IRRX CIRTX GND IRTX GND EMPTY 9 10 IR/CIR1