Frigidaire FGGF3685TS Complete Owner s Guide - Page 15

Before Setting Oven Controls

Page 15 highlights

BEFORE SETTING OVEN CONTROLS Oven Vent Location Type of oven rack The oven is vented in the rear of the cooktop behind the burner grates. When the oven is on, hot air is released through the vent. This venting is necessary for proper air circulation in the oven and good baking results. Do not block oven vent. Never close off the openings with aluminium foil or any other material. Steam or moisture may appear near the oven vent. This is normal. • Flat handle racks are used for all cooking needs and may be placed in most oven rack positions. oven vent rear of cooktop Figure 7: Do not block oven vent location Ladder Racks and Supports Removing, replacing, and arranging flat or offset oven racks To arrange - Always arrange the oven racks when the oven is cool (prior to operating the oven). To remove - Pull the oven rack straight forward until it reaches the stop position. Lift up front of oven rack slightly and slide out. To replace - Place the oven rack on the rack guides on both sides of oven walls. Tilt the front of oven rack upward slightly and slide the oven rack back into place. Be sure oven racks are level before using. Figure 8: Install ladder racks securely on ladder rack supports making sure that the hook end of the ladder racks are close to the top of the oven cavity. 1. Place the ladder racks hook side up into the support brackets located on the sides of the oven (Figure 8). 2. Place oven racks into desired positions. Note: To aid installation and movement of racks, apply a thin layer of cooking oil to the sides of the oven racks that contact the ladder supports. CAUTION Always use pot holders or oven mitts when using the oven. When cooking, the oven interior and exterior, oven racks, and cooktop will become very hot which can cause burns. Remove all oven racks and clean according to instructions provided in the Care & Cleaning section of this manual. Never pick up hot oven racks or parts. Important: Protective Liners - Do not use aluminum foil to line the oven bottom. Only use aluminum foil as recommended in this manual. Improper installation of these liners may result in risk of electric shock or fire. Do not line the oven walls, racks, bottom or any other parts of the range with aluminum foil. Doing so will alter heat distribution and may cause permanent damage to the oven interior. During self clean the oven temperatures will be hot enough to melt foil. 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44

15
BEFORE SETTING OVEN CONTROLS
Oven Vent Location
The oven is vented in the rear of the cooktop behind the
burner grates. When the oven is on, hot air is released
through the vent. This venting is necessary for proper air
circulation in the oven and good baking results. Do not
block oven vent. Never close off the openings with
aluminium foil or any other material. Steam or moisture may
appear near the oven vent. This is normal.
Ladder Racks and Supports
1. Place the ladder racks hook side up into the support
brackets located on the sides of the oven (
Figure 8
).
2. Place oven racks into desired positions.
Note: To aid installation and movement of racks, apply a
thin layer of cooking oil to the sides of the oven racks that
contact the ladder supports.
Type of oven rack
Flat handle racks
are used for all cooking needs and
may be placed in most oven rack positions.
Removing, replacing, and arranging flat or offset oven
racks
To arrange
- Always arrange the oven racks when the oven
is cool (prior to operating the oven).
To remove
- Pull the oven rack straight forward until it
reaches the stop position. Lift up front of oven rack slightly
and slide out.
To replace
- Place the oven rack on the rack guides on
both sides of oven walls. Tilt the front of oven rack upward
slightly and slide the oven rack back into place. Be sure
oven racks are level before using.
Important: Protective Liners
— Do not use aluminum foil
to line the oven bottom. Only use aluminum foil as recom-
mended in this manual. Improper installation of these liners
may result in risk of electric shock or fire. Do not line the
oven walls, racks, bottom or any other parts of the range
with aluminum foil. Doing so will alter heat distribution and
may cause permanent damage to the oven interior. During
self clean the oven temperatures will be hot enough to melt
foil.
Figure 7:
Do not block oven vent location
Figure 8:
Install ladder racks securely on ladder rack
supports making sure that the hook end of the ladder
racks are close to the top of the oven cavity.
oven vent rear of cooktop
Always use pot holders or oven mitts when using the
oven. When cooking, the oven interior and exterior, oven
racks, and cooktop will become very hot which can cause
burns.
Remove all oven racks and clean according to instruc-
tions provided in the Care & Cleaning section of this
manual. Never pick up hot oven racks or parts.
CAUTION
BEFORE SETTING OVEN CONTROLS