Frigidaire FGGF3685TS Installation Instructions - Page 14
Adjusting Low Settings on, Surface Burners, Check Ignition on Surface
View all Frigidaire FGGF3685TS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
36" GAS RANGE INSTALLATION INSTRUCTIONS 9 Prepare Burner Assemblies 9.1 Install Burner Caps To prevent flare-ups use the cooktop with all burner caps properly installed. 1. Place a burner cap on each burner head, matching the cap size to the head size (see Figure 20). The cap for each burner has an inner locating ring which centers the cap correctly on the burner head. Burner cap Locating ring Burner head To check for proper lighting: 1. Push in and turn a surface burner knob to the sparking position. All electronic surface ignitors will spark at the same time. Only the burner you are turning on will ignite. 2. The surface burner should light once the flow of gas reached the surface burner. Each burner should light within four seconds in normal operation after air has been purged from supply lines. Visually check that burner has lit. 3. Once the burner lights, the control knob should be turned out of the LITE position. Turn on each of the surface burners and check to see that they light properly and that the flames are even. Adjust settings if necessary. Burner cap Burner head Figure 20: Burner cap assembly 2. Make sure each burner cap is properly aligned and level, as shown in Figure 21. Burners may not light or burn evenly if the burner caps are not correctly place on the head. 9.3 Adjusting Low Settings on Surface Burners To adjust the low setting of surface burners: 1. Push in and turn control to LITE until burner ignites. 2. Quickly turn knob to LOWEST POSITION. 3. If burner goes out, reset control to OFF. 4. Remove the surface burner control knob. 5. Insert a thin-bladed screwdriver into the hollow valve stem and engage the slotted screw inside as shown in Figure 22. Flame size can be increased or decreased by turning the screw. 6. Adjust flame until you can quickly turn knob from the Correct cap placement Incorrect cap placement Figure 21: Burner cap placement Figure 22: Turn to adjust surface flame 9.2 Check Ignition on Surface Burners Operation of electric igniters should be checked after range and supply line connectors have been carefully checked for leaks and range has been connected to electric power. sparking position to the lowest flame position without extinguishing the flame. Flame should be as small as possible without going out. Notes: • Air mixture adjustment is not required on surface burners. • Some models have two flames on a burner. The center flame on these burners is not adjustable. 14