Frigidaire FGMC3066UF Complete Owners Guide - Page 15

Caution, Warning, Important

Page 15 highlights

BEFORE SETTING OVEN CONTROLS Oven Vent Location Types of oven racks The oven is vented as shown below. When the oven is on, warm air is released through the vent. This venting is necessary for proper air circulation in the oven and good baking results. Do not block oven vent. Never close off the openings with aluminium foil or any other material. Steam or moisture may appear near the oven vent; this is normal. oven vent location glide rack Figure 1: Do not block oven vent location CAUTION Always use pot holders or oven mitts when using the oven. When cooking, the oven interior and exterior, oven racks, and cooktop will become very hot which can cause burns. WARNING Protective Liners - Do not use aluminum foil or any other materials to line the oven bottom, walls, racks or any part of the oven. Only use aluminum foil as recommended in this manual. Improper installation of these liners may result in risk of electric shock or fire. IMPORTANT All oven racks should be removed before a self clean operation. Racks left in the oven during the high heat of the self clean function can easily discolor. The ability of the racks to easily slide in and out along the rack positions may also be affected. Figure 2: Oven rack types • Flat oven racks may be used for most cooking needs and may be placed in most oven rack positions. • The fully extendable glide rack makes food preparation easier. This oven rack has glide tracks that allow the rack to be pulled away from the oven without rubbing the sides of the oven wall. Removing, replacing, and arranging flat or offset oven racks To arrange - Always arrange the oven racks when the oven is cool (prior to operating the oven). To remove - Pull the oven rack straight forward until it reaches the stop position. Lift up front of oven rack slightly and slide out. To replace - Place the oven rack on the rack guides on both sides of oven walls. Tilt the front of oven rack upward slightly and slide the oven rack back into place. Be sure oven racks are level before using. 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59

15
Oven Vent Location
The oven is vented as shown below. When the oven is on,
warm air is released through the vent. This venting is
necessary for proper air circulation in the oven and good
baking results. Do not block oven vent. Never close off the
openings with aluminium foil or any other material. Steam or
moisture may appear near the oven vent; this is normal.
Types of oven racks
Flat oven racks
may be used for most cooking needs
and may be placed in most oven rack positions.
The fully extendable
glide rack
makes food preparation
easier. This oven rack has glide tracks that allow the
rack to be pulled away from the oven without rubbing
the sides of the oven wall.
Removing, replacing, and arranging flat or offset
oven racks
To arrange
- Always arrange the oven racks when the oven
is cool (prior to operating the oven).
To remove -
Pull the oven rack straight forward until it
reaches the stop position. Lift up front of oven rack slightly
and slide out.
To replace -
Place the oven rack on the rack guides on
both sides of oven walls. Tilt the front of oven rack upward
slightly and slide the oven rack back into place. Be sure
oven racks are level before using.
Figure 1:
Do not block oven vent location
Always use pot holders or oven mitts when using the
oven. When cooking, the oven interior and exterior, oven
racks, and cooktop will become very hot which can cause
burns.
Protective Liners — Do not use aluminum foil or any other
materials to line the oven bottom, walls, racks or any part
of the oven. Only use aluminum foil as recommended in
this manual. Improper installation of these liners may
result in risk of electric shock or fire.
All oven racks should be removed before a self clean
operation. Racks left in the oven during the high heat of
the self clean function can easily discolor.
The ability of the racks to easily slide in and out along the
rack positions may also be affected.
oven vent
location
CAUTION
WARNING
IMPORTANT
Figure 2:
Oven rack types
glide
rack
BEFORE SETTING OVEN CONTROLS