Frigidaire FGMC3066UF Complete Owners Guide - Page 18
To Set Clock to 1:30
View all Frigidaire FGMC3066UF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
SETTING OVEN CONTROLS Setting the Clock When the appliance is first powered up, 12:00 will flash in the display (Figure 6). The time of day must first be set before operating the oven. Figure 6: 12:00 in display before setting the clock To Set Clock to 1:30: 1. Press . 2. Enter 1 3 0 using numeric keys. 3. Press OK/START. Important note: The clock cannot be changed when a Self Clean, Delay Start, or cooking feature is active. Add 1 Min Use the Add 1 Min feature to set additional minutes to the timer. Each press of the key will add 1 additional minute. If Add a Min is pressed when the timer is not active, the timer will activate and begin counting down from 1 minute. To add 2 minutes to the timer: Press Add 1 Min twice. Setting 12 Hour or 24 Hour display mode The clock display mode allows you to select 12 hr or 24 hr modes. The factory pre-set clock display mode is 12 hours. To set 12 hr or 24 hr display mode: 1. Press and hold for 6 seconds. 2. Press Self Clean to toggle between 12 Hr day or 24 Hr day display modes (Figure 7). 3. Press OK/START to accept the choice Setting Timer The minute timer allows you to track your cooking times without interfering with the cooking process. The timer may be set from a minimum time of 1 minute to a maximum of 11 hours and 59 minutes. To set timer for 5 minutes: 1. Press Timer on-off. 2. Enter 5 using numeric keypad. 3. Press Timer on-off to start the timer. When set time ends, END will show in the display and the control will sound a beep three times every 30 seconds until Timer on-off key is pressed. To cancel the timer when active, press Timer on-off again. Important note: • The timer does not start or stop the cooking process. It serves as an extra minute timer that will beep when the set time has run out. The timer may be used alone or while using any of the other oven functions. • When timer is set for more than 1 hour it will display hours and minutes until 1 hour remains. When less than 1 hour remains, the display counts down in minutes and seconds. With less than 1 minute remaining, only seconds will display. • If the timer is active during a cooking process, the timer will show in the display. To view the status of any other active oven function, press the key of the cooking function once and it will appear in the display for a few seconds. Figure 7: 12 Hr dAy and 24 Hr dAy settings Changing between continuous bake setting or 12 hour energy saving The oven control has a factory preset built-in 12 Hour Energy Saving feature that will turn off the oven if the oven is left on for more than 12 hours. The control may be programmed to override this feature to bake continuously. To change between continuous bake or 12 hour energy saving feature: 1. Press and hold Timer on-off for 6 seconds 2. Press Self Clean to toggle between 12 Hour OFF or Stay On feature (Figure 8). 3. Press OK/START to accept choice. Figure 8: 12 hr energy saving (L) and continuous setting (R) 18