Fujitsu MBA3073NC Product Manual - Page 122

A.1 Setting Terminals (on NP model only) Table A.1 CN2 setting terminal (on NP model drives only) Setting item SCSI ID Write protect 1 - 2 Open Short Open Short Open Short Open Short Open Short Open Short Open Short Open Short Pin pair 3 - 4 5 - 6 7 - 8 9 - 10 Setting contents Open Open (Open) SCSI ID #0 (Common to 8-bit and 16-bit SCSI) Open Open (Open) SCSI ID #1 (Common to 8-bit and 16-bit SCSI) Short Open (Open) SCSI ID #2 (Common to 8-bit and 16-bit SCSI) Short Open (Open) SCSI ID #3 (Common to 8-bit and 16-bit SCSI) Open Short (Open) SCSI ID #4 (Common to 8-bit and 16-bit SCSI) Open Short (Open) SCSI ID #5 (Common to 8-bit and 16-bit SCSI) Short Short (Open) SCSI ID #6 (Common to 8-bit and 16-bit SCSI) Short Short (Open) SCSI ID #7 (Common to 8-bit and 16-bit SCSI) Open Open Short SCSI ID #8 (16-bit SCSI only) Open Open Short SCSI ID #9 (16-bit SCSI only) Short Open Short SCSI ID #10 (16-bit SCSI only) Short Open Short SCSI ID #11 (16-bit SCSI only) Open Short Short SCSI ID #12 (16-bit SCSI only) Open Short Short SCSI ID #13 (16-bit SCSI only) Short Short Short SCSI ID #14 (16-bit SCSI only) Short Short Short SCSI ID #15 (16-bit SCSI only) (*) Open Write operation is enabled. (*) Short Write operation is disabled. Setting item Pin pair 11 - 12 13 - 14 15 - 16 23 - 24 Setting contents Motor start mode Open Started by the START/STOP command Short Started by turning the power supply on (*) Force Narrow Open Width of 16-bit bus (*) Short Width of 8-bit bus Force Single Ended Open Follows DIFFSNS signal level on SCSI bus (*) Short Single-Ended mode Terminating power supply Open Does not supply terminating resistor power to SCSI BUS Short Supply terminating resistor power to SCSI BUS (*) * Setting at factory shipment Note: See the description of Section 5.3 for details of the setting requirements and notes. 118 Downloaded from www.Manualslib.com manuals search engine C141-E270