Fujitsu MBA3073NC Product Manual - Page 68
Fault LED: Output signal CN1-A2 pin
View all Fujitsu MBA3073NC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
b. Fault LED: Output signal (CN1-A2 pin) The HDD indicates that the write-protect status is in effect (CN1-A12 is connected to the GND, or the CN2-9 and CN2-10 are short-circuited.) A signal for driving the LED is output. 74LS06 or equivalent 150 Ω (HDD) CN1-A2 IMPORTANT This signal is temporarily driven at the GND level when the micro program reads the SCSI ID immediately after the power supply to the HDD has been switched on (it is possible to set up the SCSI ID by short circuiting CN1-A1 and CN1-A2.) c. CN1-A6 (reserved) This pin is temporarily driven at the GND level when the micro program reads the SCSI ID immediately after the power supply to the HDD has been switched on (it is possible to set up the SCSI ID by short circuiting CN1-A3 and CN1-A4, and CN1-A5 and CN1-A6.) This pin gets high impedance status except above. d. -LED and LED (+5V): Output signals (CN1-A8 pin and CN2-21, 22 pin) These signals drive the external LED as same as LED on the front of the disk drive. The electrical requirements are given in Figure 4.21. IMPORTANT 1. The external LED is identical in indication to the LED on the front of the HDD. The LED blinks during command execution. 2. Any load other than the external LED (see Subsection 4.3.5) should not be connected to the CN2-21, 22 pin (LED [V] and -LED terminals). 3. This signal is temporarily driven at the GND level when the micro program reads the SCSI ID immediately after the power supply to the HDD has been switched on (it is possible to set up the SCSI ID by short circuiting CN1-A7 and CN1-A8.) 64 Downloaded from www.Manualslib.com manuals search engine C141-E270