Fujitsu MHM2200AT Manual/User Guide - Page 166
Commands without data transfer, READ NATIVE MAX ADDRESS
View all Fujitsu MHM2200AT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 166 highlights
5.4 Command Protocol IMPORTANT For transfer of a sector of data, the host needs to read Status register (X'1F7') in order to clear INTRQ (interrupt) signal. The Status register should be read within a period from the DRQ setting by the device to 50 µs after the completion of the sector data transfer. Note that the host does not need to read the Status register for the first and the last sector to be transferred. If the timing to read the Status register does not meet above condition, normal data transfer operation is not assured guaranteed. When the host issues the command even if the drive requests the data transfer (DRQ bit is set), or when the host executes resetting, the device correct operation is not guaranteed. 5.4.3 Commands without data transfer Execution of the following commands does not involve data transfer between the host and the device. • RECABLIBRATE • SEEK • READY VERIFY SECTOR(S) • EXECUTE DEVICE DIAGNOSTIC • INITIALIZE DEVICE PARAMETERS • SET FEATURES • SET MULTIPLE MODE • SET MAX ADDRESS • READ NATIVE MAX ADDRESS • IDLE • IDLE IMMEDIATE • STANDBY • STANDBY IMMEDIATE • CHECK POWER MODE • SECURITY ERASE PREPARE • SECURITY FREEZE LOCK • FLUSH CACHE Figure 5.6 shows the protocol for the command execution without data transfer. C141-E104-03EN 5-89