Fujitsu ST5030D User's Guide - Page 46

Stylistic ST5000 Series Tablet PC User's Guide - Section Three 3. A window will appear containing a list of applications, drivers, and utilities that you can install from the Drivers and Applications CD. The components listed are color-coded in terms of their install status. Blue indicates that the component can be installed. Green indicates that the component needs to be installed separately. Grey indicates a component that is already installed; grey items can be reinstalled, but prior to installation you will receive a reminder that the component is already installed. 4. In the list, check off all the components you want to install. If you want to install all components, click [Select All]. Clicking [Select All] will select all of the blue-coded components; you must select grey and green components separately. 5. Once you have selected the components you wish to install, click [Install Selected Subsystems]; the components will be installed. 6. After the components are installed, click [OK], then click [Yes] when asked if you want to reboot the system. RESTORING THE FACTORY IMAGE The Restore Disc only restores the primary hard disk drive. If you have an optional second hard disk drive installed, it will not be restored using these utilities. The Restore Disc that came with your system contains two utilities: ■ The Recovery utility allows you to restore the original contents of the C: drive. ■ The Hard Disk Data Delete utility on this disc is used to delete all data on your hard disk and prevent it from being reused. Do not use the Hard Disk Data Delete utility unless you are absolutely certain that you want to erase your entire hard disk, including all partitions. • The use of this disc requires that you have a device capable of reading DVDs attached to your system. If you do not have a built-in DVD player, you will need to attach an external player. For more information on available external devices, visit our Web site at: us.fujitsu.com/ computers. • This disc can only be used with the system with which it was purchased. BOOT Priority Change Before restoring an image, you must first verify that your system is set up to boot from the DVD drive. To verify/ change the boot-up priority (rather than booting-up from the hard drive or an external floppy disk drive), perform the following steps: 1. Start your system and press the [F2] key when the Fujitsu logo appears. You will enter the BIOS Setup Utility. 2. Using the arrow keys, go to the Boot menu. 3. Arrow down to the Boot Device Priority submenu. Press [Enter]. 4. If "Optical Media Drive" or "CD-ROM Drive" is not at the top of the list, arrow down to the drive in the list, and press the space bar (or the + key) to move it to the top of the list. (The system attempts to boot from the devices in the order in which they are listed.). Note that the BIOS for some systems will indicate "CD-ROM Drive", even when a DVD drive is connected. 5. If you have an external DVD drive connected, proceed to the next step; otherwise, proceed to step 7. 6. If you have an external DVD drive connected: • Select the Advanced menu in the BIOS window. • Scroll down to the USB Features submenu and press the Enter key to open it. • If Legacy USB Support is disabled, press the space bar to enable it. • Scroll down to SCSI SubClass Support and press the space bar to enable it. 7. Press [F10], then click on [Yes] to exit the BIOS Setup Utility and return to the boot process. After you have changed the boot priority, you can restore a backup image when you are booting up. Procedure 1. Turn on the power to your system. 2. Ensure that you have a device that can read DVDs either installed in your system or attached externally to it. 3. Insert the Restore Disc into the drive tray. 4. Reboot your system. 5. After the system reboots, follow the instructions that appear to either restore your system image or erase all data from your hard disk. 36