GE 24959 Instruction Manual - Page 15

Learning Commands 1. Press and hold the SETUP button until the red indicator turns on, then release the button. 2. Press and release the desired mode button (TV, DVD, etc.), the red indicator blinks then stays on. 3. Press and release the LEARN button, the red indicator blinks then stays on. 4. Press and release the Learning Remote button that you want to teach (e.g. POWER). 5. Point both remotes facing each other by approximately 1 inch apart (see tips on page 12). 6. Press and hold the Original Remote button (e.g. Power) until the red indicator blinks once and stays on. If there is a learning problem, the indicator blinks for three seconds and stays on. If this happens, repeat Steps 4 to 6. 7. Repeat Steps 4-6 for other buttons you want to learn. 8. Press and release the SETUP button when all desired remote commands are learned. Code Learning is now complete. 2. 4. dvr sat vcr dvd cbl 3. 1. amp aux tv aspect learn setup no yes light page page 789 +100 enter 0 Line up your remotes (that you're learning from) in front of the learning remote on a hard surface approx. 1-inch apart. 6. 15