GE ASH08FK Owners Manual - Page 14

Install, The Air Conditioner, In The Case

Get GE ASH08FK - 8,000 BTU Electronic Room Air Conditioner PDF manuals and user guides
UPC - 084691159704
View all GE ASH08FK manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Window Installation Instructions [] INSTALL THE AIR CONDITIONER IN THE CASE [] Slide the air conditioner into the case. Reinstall the 2 screws removed earlier on each side of the case. [] Place the bottom inner case gasket between the bottom of the air conditioner and the inside bottom of the case. Fold up the ends on both sides and push them in, Front of air conditioner Bottom inner case gasket [] Attach the front grille to the case by inserting the tabs on the grille into the slots on the front of the case. Push the grille in until it snaps into place. Guide the lever carefully through the grille as you push it in. p- [] Secure the front grille to the case by replacing the screw removed in Step 3. If a screw was not removed in Step 3, secure the grille with a type A screw for models with a raise-up inlet grille or a type D screw for models with a slide-out filter. The installation is now complete.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
Window
Installation
Instructions
[]
INSTALL
THE AIR CONDITIONER
IN THE CASE
[]
Slide
the
air conditioner
into the case.
Reinstall
the
2 screws
removed
earlier
on
each side
of the case.
[]
Place the bottom
inner
case gasket
between
the bottom
of the air conditioner
and the
inside
bottom
of the case. Fold
up the ends
on both
sides
and
push
them
in,
Front
of air
Bottom
inner
conditioner
case gasket
[]
Attach
the front
grille
to the case by
inserting
the tabs
on the grille
into the slots
on the
front
of the case. Push the grille
in until
it
snaps
into
place.
Guide
the
lever
carefully
through
the
grille
as you
push
it in.
p-
[]
Secure
the front
grille
to the case
by
replacing
the screw
removed
in Step 3. If a
screw
was
not
removed
in Step 3, secure
the
grille
with
a type
A screw
for
models
with
a
raise-up
inlet
grille
or a type
D screw
for
models
with
a slide-out
filter.
The
installation
is now
complete.