GE ASH08FK Owners Manual - Page 5

COOLMode, FAN Mode, Air Direction--Side-to-Side

Page 5 highlights

When the air conditioner is turned on, it will automatically start in the setting last used. GEAppliances.com COOLMode Use tile COOLmode with HIGH (3), MED (2) or LOW(1)tim fin" cooling. Use tile INCREASEA/ DECREASE• pads to set tile desired teml)eratm'e between 64°F and 86°F in l °F increments, A them_ostat is used to maintain tile room temperature, The compressor will cycle on and off to kee I) the room at the set level of comfort, Set the them_ostat at a lower nmnber and tile indoor air will becolne coole_; Set the thelinostnt at a higher number and tile indoor air will become wamm_: NOTE:If the air conditioner is off and is then turned on while set to COOLi,t will take approximately3 minutes for the compressorto start and cooling to begin. CoolingDescriptions ForNormalCooling--Selectthe COOLmode and HIGH(3)or MED (2)tim with a middle set temperature, ForMaximumCoolino---Select the COOLmode and HIGH (3) tim with a lower set temperature, For Quieter & Nighttime Coolino--Select the COOL mode and LOW (1)tim with a middle set temperatm'e. NOTE:If you switch from a COOLsetting to OFFor to a fan setting, wait at least 3 minutesbefore switching back to a COOLsetting. FAN Mode Use tile FAN at HIGH (3), MED (2) or LOW(l) t(> provide air circulation and filtering without cooling. Since lira only settings do not provide cooling, a telnl)erature setting will not be displayed. Vent Control (on some models) Tile vent control is located on tile inside air lou\'e_ in tile lower right corne_: of tile X,_]_en set at CLOSE, only the air inside the room will be circulated and conditioned. _,_]/en set at OPEN,some inside air is exhausted outside. l (" To open flTevent, push the lever to the right. To close it, push it to the left. Air Direction--Up and Down (on some models) Fingertip pressm'e on tile horizontal lou\'e_ a(!iusts tile air direction up or down. OR Air Direction--Side-to-Side (onsomemodels) On some models, tile side-to-side air (lirecfion is a(!justed by tile louver levels or b)' grasping and m eying tile inner vertical lou','e_.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20

When the air conditioner is turned on, it will
automatically start in the setting last used.
GEAppliances.com
COOLMode
Use tile
COOL
mode
with
HIGH (3), MED (2)
or
LOW(1)tim
fin" cooling.
Use
tile
INCREASEA/
DECREASE
pads
to set tile
desired
teml)eratm'e
between
64°F
and
86°F
in
l °F increments,
A them_ostat
is used
to
maintain
tile
room
temperature,
The
compressor
will
cycle
on
and
off
to
kee I) the
room
at
the
set
level
of comfort,
Set
the
them_ostat
at
a lower
nmnber
and
tile
indoor
air
will
becolne
coole_;
Set
the
thelinostnt
at
a
higher
number
and
tile
indoor
air
will
become
wamm_:
NOTE:
If the air conditioner is off
and
is then turned on
while set to
COOL,
it will take
approximately
3 minutes
for the compressorto start and cooling to begin.
CoolingDescriptions
ForNormalCooling--Select
the
COOL
mode
and
HIGH(3)
or
MED(2)
tim
with a middle
set
temperature,
ForMaximum
Coolino---Select
the
COOL
mode
and
HIGH (3)
tim
with
a lower
set
temperature,
For Quieter
& Nighttime
Coolino--Select
the
COOL
mode
and
LOW
(1)tim
with
a middle
set
temperatm'e.
NOTE:If
you switch from a
COOL
setting to
OFF
orto
a fan setting, wait at least 3 minutesbefore switching
back to a
COOL
setting.
FAN Mode
Use
tile
FAN
at
HIGH (3), MED (2)
or
LOW(l)
t(>
provide
air circulation
and
filtering
without
cooling.
Since
lira
only
settings
do
not
provide
cooling,
a
telnl)erature
setting
will not
be displayed.
Vent Control (on
some models)
Tile
vent
control
is located
on
tile
inside
of
tile
air
lou\'e_
in
tile
lower
right
corne_:
X,_]_en set
at
CLOSE,
only
the
air
inside
the
room
will
be
circulated
and
conditioned.
_,_]/en
set
at
OPEN,
some
inside
air
is exhausted
outside.
l
("
To open flTevent, push the lever to the right.
To close it, push it to the left.
Air Direction--Up
and Down
(on some models)
Fingertip
pressm'e
on
tile
horizontal
lou\'e_
a(!iusts
tile
air
direction
up
or
down.
OR
Air Direction--Side-to-Side
(onsomemodels)
On
some
models,
tile
side-to-side
air
(lirecfion
is
a(!justed
by
tile
louver
levels
or
b)'
grasping
and
m eying
tile
inner
vertical
lou','e_.