GE ASQ10AK User Manual - Page 4
About the controls on the air conditioner-models with touch pads. - energy
UPC - 084691159841
View all GE ASQ10AK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions About the controls on the air conditioner-models with touch pads. Features and appearance will vary. COOL On FAN On ENERGY SAVER On SLEEP On TIMER On Air Conditioner Controls Remote Control On/Off Turns air conditioner on and off. Display Displays the set temperature or time remaining on timer. Mode Use to set the air conditioner to Cool or Fan mode. Increase L /Decrease M Pads Use to set temperature when in Cool mode. Fan Use to set the fan speed at Low, Med or High. Circulaire (on some models) Turn on to provide continuous side-to-side air circulation. For fixed side-to-side air direction, turn On until the desired air direction is obtained, then turn it Off. Energy Saver-Controls the fan. On-The fan and compressor cycle on and off. This results in wider variations of room temperature and humidity. Normally used when the room is unoccupied. Note: The fan will continue to run for a short time after the compressor cycles off. Off-The fan runs all the time, while the compressor cycles on and off. This switch must be set at Off in order to use the fan settings (on the mode control). Timer On-When the air conditioner is off, it can be set to automatically turn on in 1 to 24 hours at its previous setting. Each touch will set the time in hours. Off-When the air conditioner is on, it can be set to automatically turn off in 1 to 24 hours. Each touch will set the time in hours. To cancel the timer, press the Timer pad until the display time disappears. Sleep (on some models) Press to set the air conditioner to run for 8 hours before it automatically shuts off. One hour after the sleep timer is set, the set temperature will automatically increase 2°F. To cancel the sleep mode, press the Sleep pad a second time. Note: The sleep timer will be cancelled if the Timer, Energy Saver or Mode pad is pressed. Remote Control Signal Receiver Remote Control I To ensure proper operation, aim the remote control at the signal receiver on the air conditioner. I Make sure nothing is between the air conditioner and the remote control that could block the signal. I The remote control signal has a range of I Make sure batteries are fresh and installed 4 up to 21 feet. correctly-see the Care and Cleaning section. Consumer Support