GE AZ41E09DAB Owners Manual - Page 4

Other features of your Zoneline. Ventilation Control NOTE:Two shipping screws must be removed from the vent door before use.Seethe Installation Instructions in the back of this manual. If you do not plan to use the ventilation feature, leave these two screws in place. Theventilation control lever is located at the middle left side of the Zoneline unit, behind the room cabinet. Open position l When set at the closed position, only the air inside the room is circulated and filtered. When set at the open position, some outdoor air will be drawn into the room. This will reduce the heating or cooling efficiency. Energy Tip: Keep the vent control in the closed position. The room air will be filtered and circulated. Ventcontrol (shownin middleposition) Closed position To Remove the Room Cabinet Additional controls are located behind the room cabinet. To remove: Pullout at the bottom to release it from the tabs (D.Then lift up (2). @ To replace: Placethe tubs over the top rail (D. Push inward at the bottom until it snaps into place (2). Air Direction To change the air direction, remove the room cabinet. Removethe 7 louver screws that hold the louver insert in place. Flipthe louver insert 180°, replace the screws and the room cabinet. Louverscrews @ flemovethe roomcabinet andflip the/ouver insert to changethe air direction. /4 Louvesrcrews Default position