GE CWB7030SLSS Installation Instructions - Page 3

Design Information PRODUCT DIMENSIONS AND CLEARANCES NOTE: Appearance will vary by model. 1-3/5Ǝ 21-1/2Ǝ 29-3/4Ǝ 19Ǝ 1Ǝ 1-1/10Ǝ 13Ǝ TOOLS AND PARTS REQUIRED (NOT SUPPLIED) • #2 Phillips screwdriver • Hand-held drill • High speed drill bit, 3/32Ǝ diameter • 3/8Ǝ slot-head screwdriver • Level • Saw • 3/8Ǝ min. plywood for floor (if required) • Wood screws or other hardware for installing runner or shelf to support oven (if required) • Safety glasses or goggles FLUSH MOUNT INSTALLATION (Monogram Only) This installation method allows for the unit face to be inline with the cabinet face. IMPORTANT: HIGH SKILL LEVEL IN CARPENTRY IS REQUIRED. Non-standard cabinetry may be required. Flush installation of the oven will lead to the exposure of the cabinet face frame edges. Side cleats may be visible and should be a finished surface. ADVANCE PLANNING •7KHVHRYHQVPD\EHLQVWDOOHGGLUHFWO\LQWRDƎ wide oven cabinet with standard installation. • Cutout height dimensions are different for installations with an accessory storage drawer. Make sure to use the correct cutout when preparing the opening. • Allow for clearance to adjacent corners, walls, drawers, etc. • Cabinets installed adjacent to wall ovens must have an adhesion spec of at least 194ºF temperature rating. The oven must be securely installed in a cabinet that is firmly attached to the house structure. Weight on the oven door could cause the oven to tip and result in injury. Never allow anyone to climb, sit, stand or hang on the oven door. If installing the drawer accessory, the drawer must be assembled to the oven prior to installation into the cabinet. See the Accessory Storage Drawer Assembly Instructions. 3