GE CWB7030SLSS Installation Instructions - Page 7
Prepare The Opening Cont. - microwave oven
View all GE CWB7030SLSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Standard Installation Preparation IMPORTANT: Always maintain 36-3/4" minimum height from the floor to the cutout in any single or combined installation unless plastic trim is installed. PREPARE THE OPENING (cont.) Installation over another GE Appliances/ Monogram Built-In SpeedCook Oven: 30Ǝ 23-1/2Ǝ Construct solid bottom - Min. 3/8" plywood supported on all four sides. Must be able to 25-1/4Ǝ support weight of oven and contents. PREPARE THE OPENING (cont.) Installation under a GE Appliances/ Monogram Microwave Oven and over a Warming Drawer: Construct 30Ǝ 23-1/2Ǝ solid bottom - Min. 3/8" plywood supported on all four sides. Must be able to 25-1/4Ǝ support weight of oven and contents. 17-1/2Ǝ 2Ǝ Min. (3Ǝ Recommended) Per Microwave Oven Requirement 3.5Ǝ Min. (4.5Ǝ Recommended) 17-1/2Ǝ • If you are mounting a GE Appliances Appliances/Monogram Built-In SpeedCook Oven over another, use the dimensions shown. The middle rail separating the two openings may need to be larger than the 2Ǝ minimum shown. 17-1/2Ǝ Per Warming Drawer Requirement 2Ǝ Min. (3Ǝ Recommended) NOTE: Additional clearances between the cutouts may be required. Check to be sure the oven supports above the Warming Drawer location do not obstruct the required interior depth and height. See Warming Drawer installation instructions for details. CAUTION For personal safety, the mounting surface must be capable of supporting the cabinet load, in addition to the added weight of the oven and drawer, plus additional oven loads. 7