GE NX-108E User Manual - Page 12

Adding - user manual

Get GE NX-108E - Security NetworX NX-4 System PDF manuals and user guides
UPC - 782136402414
View all GE NX-108E manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

ADDING AND CHANGING USER CODES Your system must be Disarmed to add/change user codes. Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 Step 7 Step 8 Press [r]-[5]. Enter a "Master Arm/Disarm Code". NOTE: For partitioned systems, someone changing the code of another person must have access to all or more partitions than the user being changed. The ready light will flash. Enter the 2 digit (applies to NX4/6/8) or 3 digit (applies to NX8E) "user number" (always enter 2 digit such as [0] - [3] for user 3, or [1] - [0] - [0] for user 100). Enter the new four (4) or six (6) digit "user code". NOTE: To delete a user code, enter [r]-[r]-[r]-[r] for a 4-digit code, or [r]-[r]-[r]-[r]-[r]-[r] for a 6-digit code. The ready light will flash indicating you are back at Step 4 above. If the code is rejected, the sounder will beep 3 times. If another "user code" needs to be programmed, return to Step 5. Press the [#] key while the ready light is flashing to exit the User Code Programming Mode. NX-108/116/124E User manual Page 12 10/11/05

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
ADDING AND
CHANGING
USER CODES
Your system must be
Disarmed
to add/change user codes.
Step 1
Press [
r
]-[
5
].
Step 2
Enter a “Master Arm/Disarm Code”.
NOTE: For partitioned systems, someone changing the code of another person must have
access to all or more partitions than the user being changed.
Step 3
The
ready light
will flash.
Step 4
Enter the 2 digit (applies to NX4/6/8) or 3 digit (applies to NX8E) “user number” (always enter 2 digit
such as [
0
] - [
3
] for user 3, or [
1
] - [
0
] - [
0
] for user 100).
Step 5
Enter the new four (4) or six (6) digit “user code”.
NOTE
: To delete a user code, enter [
r
]-[
r
]-[
r
]-[
r
] for a 4-digit code, or [
r
]-[
r
]-[
r
]-[
r
]-[
r
]-[
r
] for
a 6-digit code.
Step 6
The
ready light
will flash indicating you are back at Step 4 above. If the code is rejected, the
sounder will beep 3 times.
Step 7
If another “user code” needs to be programmed, return to Step 5.
Step 8
Press the [
#
] key while the
ready light
is flashing to exit the User Code Programming Mode.
NX-108/116/124E User manual
Page 12
10/11/05