GE PGP989SNSS Use and Care Manual - Page 16

Installation Instructions UNPACKING YOUR COOKTOP PARTS INCLUDED (PACKED BELOW THE COOKTOP) • Blower assembly • Blower plenum • (4) Nuts (10-32 keps - nuts with lock washers attached) • (9) Sheet metal screws (8-18 x 3/8″) • Foam gasket tape (9-ft. roll) • Vent grille • Vent filter • Vent grille gasket • Cleaning cream • Scrub sponge or scraper (on some models) • Burner grates • Burner heads (1 small (A), 2 medium (B), 1 large (C)) • Burner caps (1 small, 2 medium, 1 large) • Gas pressure regulator & LP Conversion Instructions • Attached 120-volt grounded plug cord • Reflective tape Check to be sure that all packing materials and tape have been removed. This will include tape on control knobs (if applicable), adhesive tape, wire ties, cardboard and protective plastic. Failure to remove these materials could result in damage to the appliance once the appliance has been turned on and surfaces have heated. Reflective Tape Cleaning Cream Sheet Metal Screws (9) (8-18 x 3/8″) Burner Grate (2) CAUTION: GLASS IS FRAGILE DO NOT BUMP EDGE OF GLASS DURING INSTALLATION Regulator Vent Grille Burner Caps and Burner Heads Burner Cap and Burner Head Scrub Sponge CAUTION: DO NOT LIFT FROM VENT OPENING OR BUMP GLASS Burner Cap and Burner Head Blower Assembly and (4) Mounting Nuts (10-32 keps - nuts with lock washers attached) Foam Gasket Tape Vent Grille Gasket 16 Blower Plenum Vent Filter