GE PWB7030ELES Installation Instructions - Page 11

Installation Preparation Preparation WITH an Accessory Storage Drawer • PSB9120 and PWB7030 are the only approved models to be installed under 36-3/4" height with a storage drawer. CSB9120, ZSC1201, ZSC1202 and CWB7030 are not approved. • As needed, see the Standard Mount Installation Preparation OR Flush Mount Installation Preparation for configuration details. Note the modified cutout height below. • Model ZSC1202 cannot be installed with an accessory storage drawer. See installation preparation without an accessory storage drawer for this model. PREPARE THE OPENING (cont.) The Advantium/Convection 120V can be installed in combination with other GE Appliances/Monogram appliances. Always follow each product's Installation Instructions to complete the installation. Single Advantium/Convection 120V Installation: Order a 30Ǝ wide single oven cabinet or cut the opening in a wall to the dimensions shown. STANDARD MOUNT 30Ǝ 23-1/2Ǝ FLUSH MOUNT (Monogram only) 23-1/2Ǝ 25-1/4Ǝ K* Min. 21Ǝ 36-3/4Ǝ Min. Construct solid bottom - Min. 3/8" plywood supported on all four sides. Must be able to support weight of oven and contents. 22-5/8Ǝ 36-3/4Ǝ Min. Construct solid bottom - Min. 3/8" plywood supported on all four sides. Must be able to support weight of oven and contents. *See table for desired reveals on sides. Dimension 1/8" 1/4" Reveal Reveal K 30" 30-1/4" • Allow 2-1/8Ǝ case trim overlap on the sides, 1-1/16Ǝ overlap on the top and 7/8Ǝ overlap on the bottom of the opening for all models. • Oven overlaps will conceal cut edges on all sides of the opening. • When installed over a single oven or a warming drawer, allow at least 2Ǝ between the two openings. This separation will provide clearance for bottom overlap of the Advantium/Convection 120V and the other appliance overlaps. • The support must be level and rigidly mounted, flush with the bottom edge of the cutout. 11