Gigabyte GA-K8U User Manual - Page 67

English After the RAID array has been created successfully, its information shows up at RAID Array List. RAID BIOS Setup Utility (c) 2004 ULi Corporation www.uli.com.tw Create RAID 0 Striping for Performance Create RAID 1 Mirroring for Reliability Create JBOD for integrated Capacity Stripe Size 64K SPACE : Select Delete RAID Settings & Partition , : Moving Cursor Delete All RAID Settings & Partition Rebuild RAID Array Enter : Select & Finish ESC : Exit Drive Model Channel 1 Master : ST3120026AS Channel 2 Master : ST3120026AS RAID Array A : RAID Array B : RAID Array C : Capacity 120034 MB Mode SATA 1 SATA 1 RAID Type 1 Capacity 120034 MB 120034 MB Stripe Size RAID Array/Type RAID Name ALi_RAID 3. Create JBOD for integrated Capacity Press Enter on Create JBOD for integrated Capacity item. A "J" flash cursor appears at the Drive Select Menu for the user to choose the first drive for JBOD. Use Space key to select the desired drive for JBOD. Press Enter to finish JBOD drive selection. The maximum number of drives for JBOD array is four and the minimum is two. RAID BIOS Setup Utility (c) 2004 ULi Corporation www.uli.com.tw Create RAID 0 Striping for Performance Create RAID 1 Mirroring for Reliability Create JBOD for integrated Capacity Stripe Size 64K SPACE : Select Delete RAID Settings & Partition , : Moving Cursor Delete All RAID Settings & Partition Enter : Select & Finish Rebuild RAID Array ESC : Exit Select JBOD Drives Drive Model J Channel 1 Master : ST3120026AS J Channel 2 Master : ST3120026AS Mode SATA 1 SATA 1 Capacity 120034 MB 120034 MB RAID Array/Type RAID Array A : RAID Array B : RAID Array C : Capacity RAID Type Stripe Size RAID Name The prompt "Data on RAID Drives will be deleted (Y/N)?" appears after two drives are properly assigned. Press Y, and then some necessary information will be written to the drives, which will destroy the original data in the drives. Next, the Array Name input line appears for the user to key in a name for the newly created array. The effective characters for an array name is 0-9, A-Z, a-z, space and underscore. After the RAID array has been created successfully, its information shows up at RAID Array List. Make sure the data in drives is no longer in use before creating JBOD. - 67 - Appendix