Gigabyte GA-M52S-S3P Manual - Page 23
IDE IDE Connector, SATAII0/1/2/3 SATA 3Gb/s Connectors
View all Gigabyte GA-M52S-S3P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
English 6) IDE (IDE Connector) The IDE connector supports up to two IDE devices such as hard drives and optical drives. Before attaching the IDE cable, locate the foolproof groove on the connector. If you wish to connect two IDE devices, remember to set the jumpers and the cabling according to the role of the IDE devices (for example, master or slave). (For information about configuring master/slave settings for the IDE devices, read the instructions from the device manufacturers.) 40 39 2 1 7) SATAII0/1/2/3 (SATA 3Gb/s Connectors) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The nVIDIA® nForce 520 controller supports RAID 0, RAID 1 and RAID 0+1. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. 1 SATAII3 7 1 SATAII2 7 7 SATAII1 1 7 SATAII0 1 Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND • A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are to be used, the total number of hard drives must be an even number. • A RAID 0+1 configuration requires at least four hard drives and the total number of hard drives must be an even number. - 23 - Hardware Installation