Gigabyte MP30-AR0 Manual - Page 18

11) FP_1 (Front Panel Header/For Server System) Connect the power switch, reset switch, chassis intrusion switch/sensor and system status indicator on the chassis to this header according to the pin assignments below. Note the positive and negative pins before connecting the cables. 2 24 1 23 Pin No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 Signal Name PWR_LED+ 5VSB KEY ID_LED+ PWR_LED- ID_LED- HDD_LED+ SYS_STATUS- HDD_LED- SYS_STATUS+ PWR_BTN LAN1_LED+ PWR_BTN (GND) LAN1_LED- RST_BTN SDA RST_BTN (GND) SCL ID_BTN CASE_OPEN ID_BTN (GND) LAN2_LED+ NMI_BTN LAN2_LED- Definition Power LED Anode Front Panel Power Key System ID LED Anode Power LED Cathode System ID LED Cathode HDD Activity LED Anode System Fault LED Cathode HDD Activity LED Cathode System Fault LED Anode Power Switch NIC#1 Activity LED Anode Power Switch (GND) NIC#1 Activity LED Cathode Reset Switch SMBus SDA Reset Switch (GND) SMBus SCL System ID Switch Chassis Intrusion System ID Switch (GND) NIC#2 Activity LED Anode NMI to CPU Switch NIC#2 Activity LED Cathode The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin assignments are matched correctly. Hardware Installation - 18 -