Gigabyte MSH61DI Manual - Page 35

SATA Port 0/SATA Port 1/mSATA, LBA/Large Mode, Block Multi-Sector Transfer

Get Gigabyte MSH61DI PDF manuals and user guides View all Gigabyte MSH61DI manuals
Add to My Manuals
Save this manual to your list of manuals

Page 35 highlights

2-2-3 SATA Configuration SATA Configuration SATA Port 0/SATA Port 1/mSATA The category identifies Serial ATA and mSATA types of hard disk that are installed in the computer. System will automatically detect HDD type. Note that the specifications of your drive must match with the drive table. The hard disk will not work properly if you enter improper information for this category. Hard drive information should be labeled on the outside device casing. Enter the appropriate option based on this information. Type Auto: Set parameters automatically. (Default setting) CD-ROM: Use for ATAPI CD-ROM drives or double click [Auto] to set all HDD parameters automatically. ARMD: Use ARMD drive is installed here. LBA/Large Mode Configure the device type in the specific IDE channel support LBA Mode. Option available: Auto/Disabled. Default setting is Auto. Block (Multi-Sector Transfer) Configure the information of Multi-Sector Transfer Mode. Auto: The data transfer from and to the device occurs multiple sectors at a time if the device supports it. Disabled: The data transfer from and to the device occurs one sector at a time. Option available: Auto/Disabled. Default setting is Auto. - 35 - BIOS Setup

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
- 35 -
BIOS Setup
2-2-3
SATA Configuration
SATA Configuration
SATA Port 0/SATA Port 1/mSATA
The category identifies Serial ATA
and mSATA types of hard disk
that are installed in the computer.
System will automatically detect HDD type.
Note that the specifications of your drive must match with the drive table. The hard disk will not work
properly if you enter improper information for this category.
Hard drive information should be labeled on the outside device casing. Enter the appropriate option
based on this information.
Type
Auto
: Set parameters automatically. (Default setting)
CD-ROM
: Use for ATAPI CD-ROM drives or double click [Auto] to set all HDD parameters
automatically.
ARMD
: Use ARMD drive is installed here.
LBA/Large Mode
Configure the device type in the specific IDE channel support LBA Mode.
Option available: Auto/Disabled. Default setting is
Auto
.
Block (Multi-Sector Transfer)
Configure the information of Multi-Sector Transfer Mode.
Auto
:
The data transfer from and to the device occurs multiple sectors at a time if the device
supports it.
Disabled
:
The data transfer from and to the device occurs one sector at a time.
Option available: Auto/Disabled. Default setting is
Auto
.