Graco 1757845 Instruction Manual - Page 10
Rear-facing, Latch
UPC - 047406106110
View all Graco 1757845 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
REAR-FACING INSTALLATION WITH LATCH 1 LATCH belt must be routed through opening in child restraint for rear-facing mode. (see page 23, fig. k). Belt must lay flat and not be twisted. 2 Adjust child restraint to recline position (see fig. a and pages 18 and 19, fig. b) Place rear-facing on vehicle seat equipped with LATCH anchors. 3 For ease of installation, extend LATCH belt to its maximum length. 4 Hook connectors to vehicle lower anchors (fig. b). Pull connectors to be sure they are securely attached to the anchor points. (fig. c). 5 Press down firmly in center of child restraint while pulling LATCH adjustment belt. (fig. d). 6 Pull front to back and left to right to check for secure installation (fig. e). Check that the lower anchorage belt stays tight and does not slip from the tightened position. If it does not stay tight, try another seating position or contact Customer Service (see back cover). 7 Check level indicator on child restraint. Vehicle must be on level ground and child in child restraint when checking level indicator. Ball MUST be entirely in green zone (fig. f). If necessary, place rolled towels under child restraint, at vehicle seat crease, until entire ball is in green zone. Then re-check level indicator. DO NOT use tether rear-facing. Tether must be stored (see "Tether Storage" page 32). Periodically check that child restraint is securely installed and properly leveled; adjust if necessary. 8