Graco 1757845 Instruction Manual - Page 33
Locking Clip
UPC - 047406106110
View all Graco 1757845 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
VEHICLE SEAT BELTS (continued) c Locking Clip WARNING Avoid serious injury or death: • Failure to use locking clip where required will result in child restraint not being securely held in place. • Remove locking clip from seat belts when not being used with child restraint. • DO NOT use locking clip as a vehicle seat belt shortener. 5 Test installation to see if child restraint is secure. If not secure, additional belt tightening may be required: • Unbuckle vehicle seat belt. • Hold belts together and remove locking clip. • Shorten length of lap belt portion slightly by pulling belt through latch plate. • Re-attach locking clip. • Buckle vehicle seat belt. Press child restraint further down into vehicle seat cushion to help buckle vehicle seat belt. Test installation to see if child restraint is secure. If not secure, repeat above step until secure. You MUST use locking clip provided with child restraint with a vehicle seat belt that slides freely through the latch plate or the lap belt cannot be tightly secured. 1 Install child restraint and tighten vehicle seat belt. 2 Hold seat belts together at latch plate (fig. a) then unbuckle. 3 Slide locking clip on seat belts approximately 1/2 inch (1 cm) away from latch plate. 4 Re-buckle seat belt. (fig. a) 1/2 inch (1 cm) 31