Graco 1757845 Instruction Manual - Page 12

FORWARD-FACING INSTALLATION WITH LATCH 1 LATCH belt must be routed through opening in child restraint for forward-facing (see page 23, fig. l). Belt must lay flat and not be twisted. 2 Adjust car seat to upright position (see fig. a and pages 18 and 19, fig. b). Secure recline stand into Upright Position by pushing tabs into lock position. Place forward-facing on vehicle seat equipped with LATCH anchors. 3 For ease of installation, extend LATCH belt to its maximum length. 4 Hook connectors to vehicle lower anchors (fig. b). Pull connectors to be sure they are securely attached (fig. c). 6 Pull front to back and left to right to check for secure installation (fig. e). Check that the lower anchorage belt stays tight and does not slip from the tightened position. If it does not stay tight, try another seating position or contact Customer Service (see back cover). 7 Attach tether strap hook (A) to anchor hardware (B) and tighten adjustment belt to remove any slack (fig. f). Belt must lay flat and not be twisted. Periodically check that child restraint is securely installed; adjust if necessary. 5 Press down firmly in center of child restraint to compress vehicle seat cushion while tightening LATCH belt by pulling adjustment belt (fig. d). Use your knee to press down in center of child restraint (fig. d). 10