Graco 1757845 Instruction Manual - Page 14
Rear-facing, Vehicle Seat Belts
UPC - 047406106110
View all Graco 1757845 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
REAR-FACING INSTALLATION WITH VEHICLE SEAT BELTS WARNING LATCH belt MUST be stored when using vehicle seat belt to install child restraint. 1 Store LATCH belt by attaching to connectors through forward-facing openings (see page 25, fig. r). • Attach connectors to storage bar on each side (fig. a). • Adjust LATCH belt to remove excess slack by pulling adjustment belt. 2 Adjust car seat to recline position (see fig. b and pages 18 and 19, fig. b). Place rear-facing on vehicle seat. 3 Thread vehicle seat belt through openings and buckle belt. 5 Pull front to back and left to right to check for secure installation (fig. d). Vehicle lap belt MUST stay tight. If not secure, see "Vehicle Seat Belts" page 26. 6 Check level indicator on child restraint. Vehicle must be on level ground and child in child restraint when checking level indicator. Ball MUST be entirely in green zone (fig. e). If necessary, place rolled towels under child restraint, at vehicle seat crease, until entire ball is in green zone. Then re-check level indicator. DO NOT use tether rear-facing. Tether must be stored (see "Tether Storage" page 32). Periodically check that child restraint is securely installed and properly leveled; adjust if necessary. 4 Press down firmly in center of child restraint to compress vehicle seat cushion while tightening vehicle seat belt (fig. c). 12