Haier CWH18B CWH18A Manual - Page 10

2. Assemble sill angle bracket to support brackets at the marked position as shown. Hand tighten, but allow for any changes later. A B C F D Window Sash View A B C G H I J A.½" Screws B.Washers C.Lock Washers D.1/5" Nuts E.Right Supoort Brackets F.Right Supoort Brackets E G.Angle Brackets H.Washer I.Lock Washer J.1/4" Nuts 3. Install support brackets (with sill angle brackets attached) to correct hole in bottom of cabinet as shown. A. Window sash C. ³⁄₄" screw B. Hole in side curtain 5. Use ¹⁄₈" drill bit to drill a starter hole through the hole in the shutter clamp and windowsill. 6. Insert one of the ³⁄₄" screws through the hole in the side curtain clamp and into the windowsill. 7. Repeat for right-hand curtain. Windowsill View A B C A. Side curtain C. Side curtain clamp A B. ³⁄₄" screw A.½" Screws 4. Tighten all 6 bolts securely. 5. Check to make sure that the cabinet is slanted slightly downward on the outside. If necessary, re-adjust support bracket. Complete Window Installation Insert foam seal behind the top of the lower window sash and against the glass of the upper window. A Attach Side Curtains to Window 1. Pull the left-hand curtain out until it fits into the window channel. 2. Use ¹⁄₈" drill bit to drill a starter hole through the hole in the side curtain and window sash. 3. Insert one of the ³⁄₄" screws through the left-hand curtain and into the window sash. 4. Repeat for the right-hand curtain. B A. Top of lower window sash B. Foam seal 9