Haier DWL3225SDSS Product Manual - Page 14
Drain Hose, 11a. Waste Disposer & Air Gap, 11b. No Waste Disposer & Air Gap
View all Haier DWL3225SDSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
English 8. Turn shutoff valve "H" to "ON" position. Flush water into a bucket to get rid of particles that may clog the inlet valve. 9. Turn shut-off valve to "OFF" position Drain hose 10. Cut a 1-1/2" (3.8cm) diameter hole in cabinet wall or floor on the side of the opening closest to the sink. 11. Connect drain hose to waste tee or waste disposer following one of the following methods: a waste disposer no waste disposer an air gap no air gap* an air gap no air gap* 11a. 11c. 11b. 11d. *An air gap is recommended 11a. Waste disposer & air gap 1. Remove the disposer knockout plug. Cut end of drain hose "I" if needed (do not cut ribbed section). 2. Attach drain hose to air gap "J" with large spring-type clamp "K". If the drain hose was cut, use a 1-1/2" to 2" (3.8 to 5 cm) screw-type clamp*. 3. Use a rubber hose *connector "L" with spring or screw-type clamps* "M" to connect air gap to disposer inlet "N". The connection "N" MUST be made before drain trap "O" and at least 20" (50.8cm) above the floor where dishwasher will be installed. Go to step 12. 11b. No waste disposer & air gap 1. Cut end of drain hose "I" if needed (do not cut ribbed section). 2. Attach drain hose to air gap "J" with large spring- P type clamp. If the drain hose was cut, use a 1-1/2" to 2" (3.8 to 5 cm) screw-type clamp*. 3. Use a rubber hose *connector "L" with spring or screw-type *clamps "M" to connect air gap to waste tee "P". This connection "P" MUST be made before drain trap "O" and at least 20" (50.8 cm) above the floor where dishwasher will be installed. Go to step 12. * Parts available from local pumbing supply stores. 13