Haier HHV3330DBBB HHV3330 Manual - Page 10

either side of hood center. In extreme off-center installations, one

Get Haier HHV3330DBBB PDF manuals and user guides View all Haier HHV3330DBBB manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

English 14. 3¼" x 10" Ducted Discharge Only: Remove Tape from damper flap and attach Damper/Duct Connector over knockout opening with screws removed in Step 4 under PREPARING HOOD. Make sure damper Pivot is nearest to Top/Back Edge of hood. UP TO 1"SIDE-TO-SIDEADJUSTMENT TAPE TOP/BACK EDGE DAMPER/DUCT CONNECTOR (Vertical discharge position shown) PIVOT 15. 7"Round Ducted Discharge Only: Re-install 7 "Round Duct Plate removed in Step #1 under "PREPARING HOOD" section. Install a 7" round damper (purchase separately). Damper flap must open freely in direction of airflow (away from range hood). NOTE: To accommodate off-center ductwork, the Damper/Duct Connector can be installed up to 1-inch on either side of hood center or the 7" Round Duct Plate can be installed up to ½" on either side of hood center. In extreme off-center installations, one end of the duct connector may need to be trimmed to clear the electrical cable clamp. 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
English
9
14. 3¼” x 10” Ducted Discharge Only: Remove Tape from damper flap and
attach Damper/Duct Connector over knockout opening with screws removed
in Step 4 under PREPARING HOOD.
Make sure damper Pivot is nearest to Top/Back Edge of hood.
15.
7”Round Ducted Discharge Only: Re-install 7 ”Round Duct Plate removed
in Step #1 under “PREPARING HOOD” section. Install a 7” round damper
(purchase separately). Damper flap must open freely in direction of airflow
(away from range hood).
NOTE:
To accommodate off-center ductwork, the Damper/Duct
Connector can be installed up to 1-inch on either side of hood
center or the 7” Round Duct Plate can be installed up to ½” on
either side of hood center. In extreme off-center installations, one
end of the duct connector may need to be trimmed to clear the
electrical cable clamp.
UP TO 1”SIDE-TO-SIDEADJUSTMENT TAPE
TOP/BACK EDGE
DAMPER/DUCT
CONNECTOR (Vertical
discharge position shown)
PIVOT