Haier HLC1700AXS User Manual - Page 30

Moving Or Storage Precautions

Get Haier HLC1700AXS PDF manuals and user guides View all Haier HLC1700AXS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

ENGLISH MOVING OR STORAGE PRECAUTIONS • Unplug the electrical cord from the wall outlet. • Turn off the water supply faucets. • Disconnect the water hoses and place them in the washtub. • Remove the drain hose from the drain and snap it back into the clips located on the back of the washer. • Retract adjustable feet. Loosen locking nuts as far as possible and thread feet into the cabinet as far as possible. • Reinstall the transportation hardware as shown below. Install the Transportation Bolts with the original four screws. Remove the back plate by removing (4) screws Position the (4) rubber grommets and plastic spacers Insert the bolts and tighten with wrench Replace the back plate and the (4) screws to hold it in place 28

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
MOVING OR STORAGE PRECAUTIONS
•
Unplug the electrical cord from the wall outlet.
•
Turn
off
the water supply faucets.
•
Disconnect the water hoses and place them in the washtub.
•
Remove the drain hose from the drain and snap it back into the clips located on the
back of the washer.
•
Retract adjustable feet. Loosen locking nuts as far as possible and thread feet into
the cabinet as far as possible.
•
Reinstall the transportation hardware as shown below. Install the Transportation
Bolts with the original four screws.
Remove the
back plate
by removing
(4) screws
Position the
(4) rubber
grommets
and plastic
spacers
Replace the
back plate
and the (4)
screws to
hold it
in place
Insert the bolts
and tighten
with wrench
28
ENGLISH