Haier HLC1700AXS User Manual - Page 31
Normal Operating Sounds, Troubleshooting
View all Haier HLC1700AXS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
ENGLISH TROUBLESHOOTING NORMAL OPERATING SOUNDS The following sounds are normally heard during the operation of the washer: • Tumbling sounds: This is normal as the heavy wet clothes in the washer are continuously being tossed around. • Air rushing noise: This happens when the washer tub spins at a very high RPM. • Wash and rinse cycles going on and off will also make clicking sounds as well as spraying and water splashing sound. • Drain pump operational sound, when dirty water is being drained. TROUBLESHOOTING TROUBLE Washer/Dryer does not start POSSIBLE CAUSE The appliance is not properly plugged in. POSSIBLE REMEDY Insert the plug into the power socket securely. The wash/dry cycle does not start The washer does not take in water There is water on the floor The water will not drain from the washer A. The door has not been closed properly. A. Close the door and try it again. B. The delay start has been selected. B. Cancel the delay start A. The inlet hose is not connected to the tap. B. The water tap has not been opened. C. The faucet or valve may need to be open more fully. D. There is no water supply in the house or the water pressure is too low. A. See "installation" (p12-13) B. Open the water tap. C. Make sure water hoses are not kinked, twisted, or tangled. D. Check another faucet in the house to make sure that household water pressure is adequate. A. The water leakage could be caused by an improperly connected drain hose or water hose. B. You may have a clogged or slow draining sink or standpipe. C. You may have used incorrect or too much detergent A. Check all connections. B. Check plumbing or consult a professional plumber. C. Make sure to use HE (High Efficiency) detergent only. A. This could be caused by your drain hose set up. The drain hose support bracket should be looped over a sink or into a standpipe that is between 2'6" and 3'3" high. B. Button trap may be full A. Make sure the end of the hose is not immersed in water. B. Check to see that the button trap is clean and dust free. 29