Haier HWD100-FD756DD UM - Page 28

Note: Foamformation

Get Haier HWD100-FD756DD PDF manuals and user guides View all Haier HWD100-FD756DD manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

GB 8-Troubleshooting Note: Foamformation If too much foam is inspected duringspincycle,motor stops anddrainpump willbe activated for 90 seconds.If that eliminationof foam failsup to 3 times, programme ends without spinning. ance, disconnect the power supply and contact the customer service. 8.4 In case of power failure The current progra●mme and its setting will be saved. When power supply is restored operation will be re- sumed. ● In case of power failure during programme run door opening is mechanicaly blocked. If the laundry is to be removed,the water levelmust not be visiblein the glass door. - Danger of scalding! Lower the w●ater level according to step 1 to 6 of chapter CARE AN CLEANING (PUMP FILTER). Pull lever (A) beneath service ap (Fig.8-4) until door is unlocked by a gentle click. Fix all parts and close the service ap. 28

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
GB
8-Troubleshooting
28
8.4 In case of po
●
wer failure
The current programme and its setting will be saved.
When power supp
●
ly is restored operation will be re-
sumed.
In case of power failure during programme run door
opening is mechanicaly blocked. If the laundry is to
be removed, the water level must not be visiblein the
glass door. - Dan
●
ger of scalding!
Lower the water level according to step 1 to 6 of
chapter CARE AN CLEANING (PUMP FILTER).
Pull lever (A) beneath service
ap (Fig. 8-4) until
door is unlocked by a gentle click.
Fix all parts and close the service
ap.
ance, disconnect the power supply and contact the customer service.
Note: Foamformation
If too much foam is inspected during spin cycle, motor stops and drain pump willbe ac-
tivated for 90 seconds. If that eliminationof foam failsup to 3 times, programme ends
without spinning.