Haier HWD100-FD756DD UM - Page 30

Warning

Page 30 highlights

GB 9-Installation 9.4 Aligning the appliance Adjust all feet (Fig.9.4) to achievea complete level position. This will minimize vibrations and thus noise duringuse.It willalsoreduce wearandtear.We recommend to use a spirit levelfor adjustment. Floor should be as stable and flat as possible. 1. Loose the locknut (1) by using a wrench. 2. Adjust the high by turning thefoot (2). 3. Tighten locknut (1) against the housing. ● 9.5 Drain Water Connection Fixthe water drainho●seproperly to the piping.The hosehasto reachat one point aheight between 80 and 100 cm above the appliance bottom line! If possiblekeep always drain ● WARNING! Use only the supplied hose set for the connection. Neverreuse old hose sets! Only connect to cold water supply. Before connection, check whether the water is clean and clear. 30

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36

GB
9-Installation
30
9.4 Aligning the appliance
Adjust all feet (Fig. 9.4) to achieve a complete level
position. This will minimize vibrations and thus noise
during use.It willalsoreduce wear and tear.We recom-
mend to use a spirit level for adjustment. Floor should
be as stable and flat as possible.
1.
Loose the locknut (1) by using a wrench.
2.
Adjust the high by turning thefoot (2).
3.
Tighten locknut
(1) against the housing.
9.5 Drain Water Co
nnection
Fixthe water drainhose properly to the piping. The hose hasto reach at one point a height
between 80 and 100
cm above the appliance bottom line! If possible keep always drain
WARNING!
Use only the supplied hose set for the connection.
Never reuse old hose sets!
Only connect to cold water supply.
Before connection, check whether the water is clean and clear.