Haier HWD1500 User Manual - Page 11

English • As shown in figure1, remove all the packing materials (including the foam base). Upon opening of the package, water drops may be seen on the plastic bag and the porthole. This is a normal phenomenon resulting from water tests in the factory. Water tests are conducted to check for leakage. Fig. 1 • Remove three transportation bolts as shown in figure 2A. The bolts protect the appliance from shock during transportation. The steps below should be followed before using the appliance: 1. Remove the back plate of the washing machine. To remove this you must remove three screws holding the panel. 2. Now you could remove the transportation bolts. While removing the three bolts from the rear of the washing machine, remove the rubber hoses which are behind the transportation bolts inside the unit at the same time. Remove themetal bracket and save in a safe place for later use. Back Plate 3. Reinstall the back plate. 4. Fill the holes left by the bolts with plastic plugs. (Attention: The bolts and rubber hose should be kept in a safe place for later use.) (Fig. 2B) Fig. 2 • Leveling the washing machine: There are adjustable feet under the bottom of the washing machine. Before use, the washing machine should be adjusted, as shown in figure 3, so that it is level. • Leveling legs can be adjusted by turning them counterclockwise to raise your washer or clockwise to lower your washer. Metal bracket Screws A Transportation Bolt B Fig. 3 10